How do I prevent the spread of sawdust when using my router? Written by Chris Kortendick on 11/03/2017.
Can I swap out the 3/8″ chuck on the DrillMate for a 1/2″ chuck? Written by Chris Kortendick on 09/27/2017.
Do you offer beams for the CircleGuideKit longer than 20″? Written by Chris Kortendick on 05/25/2017.
Do I have to use a plunge base router with the SignCrafter™ or SignPRO™? Written by Chris Kortendick on 05/15/2017.
What is the largest diameter hole saw one can use to make a 45º angle cut with the DrillMate? Written by Chris Kortendick on 05/12/2017.
What are size drill bits does the 1312 DrillBlock accommodate? Written by Chris Kortendick on 02/14/2017.
Can the DrillMate be used to start holes in porcelain tile shower walls? Written by Chris Kortendick on 02/14/2017.
Is the bushing block in the 1312 DrillBlock heat treated (hardened)? Written by Chris Kortendick on 02/14/2017.
What type of cuts do the different router bits make and what are they used for? Written by Chris Kortendick on 02/03/2017.
How do I use the centering pin to center the base plate on my router? Written by Chris Kortendick on 12/08/2016.
Does Milescraft make a 1/2″ chuck that will fit the DrillMate? Written by Chris Kortendick on 11/15/2016.
What should I do if more horizontal depth is required than the thickness selector cam permits? Written by Chris Kortendick on 11/07/2016.
How do I prevent marring my pen tip during assembly, using the PenPress? Written by Chris Kortendick on 10/11/2016.
Hinge Mortise – What to do if the stop on the jamb prevents the template from going over it. Written by Chris Kortendick on 08/15/2016.
What is the difference between the Drill90 and the Drill90PLUS? Written by Chris Kortendick on 08/09/2016.
Can I purchase additional length of hose for the DustRouter? Written by Chris Kortendick on 06/22/2016.
What is the standard length of hose that comes with the DustRouter? Written by Chris Kortendick on 06/22/2016.